![]() The Home Menu may be accessed by pressing the button on the remote that looks like a house, then selecting System Setup, and finally Input Setup. How can I make use of the optical port on my Pioneer receiver? You should then immediately release the button on your remote that corresponds to the device you intend to configure once you have pressed it. Maintain pressure on the “code search” button located on your Pioneer remote and press it repeatedly. Start the device you’re configuring by turning it on manually… What is the procedure for programming a Pioneer receiver? How can I link my Pioneer receiver with my television?Īttach a Coaxial Digital Cable, Optical Digital Cable, or Audio cable to your television’s Audio Output jack.Īttach the jacks on the opposite end of the wire to the appropriate ports on the audio-video receiver or home theater system. ![]() Then, press the Device button to save the code.Step 6: To change the password for the television, you need to press the “TV” key. For unknown codes, repeat the operation, but instead of entering the manufacturer codes, press Select slowly and repeatedly until the device turns off. Press the Device button to turn the device off to ensure the operation worked correctly. Press the Device button before entering the manufacturer codes until the LED light blinks twice. Release the Setup button and proceed when the LED light blinks once. Press and hold the Setup button until the LED light comes on, then off. DVD players are programmed to the VCR button, while audio equipment is programmed to the AUD button.įor universal models that are designed to work with complete home theater systems, begin by turning on the device. Press TV before pressing one of the remote’s up arrow buttons slowly and repeatedly until the TV turns off.įor the following programming instructions, Device button refers to the TV, VCR and AUD buttons, while device refers to TVs, VCRs, DVD players and audio equipment. For unknown codes, turn the TV on and enter Set Mode. Then, enter the manufacturer codes until the TV turns off. ![]() ![]() Press “0, 0, 2, 5” in that order until the LED light blinks twice and turns off. Once the light begins to flash, press down on only the CATV button until the light stays on. Repeat this step if the light stops flashing. The first programming scenario begins by entering Set Mode by pressing down both the CATV and the TV button for three seconds until the remote’s LED light flashes repeatedly. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |